Prowler V6-3.5L VIN G (1999)
Engine Mount: Service and Repair
Front Mount
Right Engine Mount
Removal
1. Disconnect negative cable from battery.
2. Raise vehicle on hoist.
Right Engine Mount Removal/Installation
3. Remove right and left engine mount isolator attaching nuts from isolator to crossmember mount.
4. Support the engine with a jack and a block of wood across the full width of oil pan.
5. Remove bolts holding engine mount bracket to engine.
CAUTION: To prevent damage to propeller shaft bushings, raise engine only enough for mount removal and installation.
6. Raise engine only enough to clear isolator stud. Remove engine mount isolator with engine mount bracket.
7. Remove isolator from engine mount bracket.
Installation
1. Install engine mount isolator to engine mount bracket. Tighten the nuts to 101 Nm (75 ft. lbs.).
2. With engine raised SLIGHTLY, position isolator and engine mount bracket to engine. Install bolts and tighten to 60 Nm (45 ft. lbs.).
NOTE: The Left engine mount isolator has a locating dowel that aligns to a crossmember mount locating slot.
3. Lower engine while guiding engine mount isolator studs into crossmember mounts making sure that left engine mount isolator locating dowel is in
correct position.
4. Install right and left engine mount isolator to crossmember nuts. Tighten nut to 101 Nm (75 ft. lbs.).
5. Remove jack and lower vehicle.
6. Connect negative battery cable.
Left Engine Mount
Removal
1. Disconnect negative cable from battery.
2. Raise vehicle on hoist.