Plymouth Workshop Manuals
Prowler V6-3.5L VIN G (1999)
Heating and Air Conditioning > Sensors and Switches - HVAC > Evaporator Temperature Sensor / Switch > Component Information > Locations > Page 4613
Evaporator Temperature Sensor / Switch: Service and Repair
Fig 29 Evaporator Fin Sensor Location
EVAPORATOR FIN SENSOR
NOTE: The evaporator fin sensor can be removed without removing the Unit Housing from the vehicle.
1. Disconnect sensor wiring connector from behind the glove box.
1. There are three pilot holes available for the probe.
The top hole is for service.
If top hole was not used by previous probe, install probe in top hole.
2. If previous sensor was removed from top hole, use a small plastic stick and make a new hole.
Make the hole 1/4 inch above or below the original hole in the evaporator core.
3. Insert new sensor into hole between evaporator fins.
|[PREV PAGE] [NEXT PAGE]|