Prowler V6-3.5L VIN G (1999)
11. Install Remover, Roll Pin, Special Tool 6831A, or equivalent through center of roll pin on intermediate steering shaft coupler at steering gear.
12. Remove roll pin from intermediate steering shaft coupler using the following procedure. Using a wrench, hold threaded bolt on Remover, Roll Pin,
Special Tool 6831A, or equivalent from rotating. Using a second wrench, tighten nut against sleeve of special tool. This will pull the roll pin out of
the coupler on the intermediate steering shaft.
13. Remove intermediate steering shaft from steering gear by sliding it off input shaft.
14. Remove power steering fluid pressure hose and return hose from steering gear.