Prowler V6-3.5L VIN G (1999)
7. Install the airbag module in steering wheel. Install the 3 original or correct replacement airbag module attaching bolts. Tighten the airbag module
attaching bolts to a torque of 10 Nm (90 inch lbs.).
CAUTION: When reconnecting battery on a vehicle that has had the air bag module removed, ensure no occupants are in the vehicle and the
following procedure is used.
8. Reconnecting of the battery negative cable is to be done using the steps in the procedure listed below.
-
Remove forward console or cover as necessary.
-
Connect Diagnostic Readout Box (DRB) scan tool to Air Bag System Diagnostic Module (ASDM) diagnostic 6-way connector, located at right
side of the ASDM module.
-
Turn ignition key to ON position. Exit vehicle with the DRB scan tool. Install the latest version of the proper diagnostic cartridge into the DRB
scan tool.
-
Ensuring that their are no occupants in the vehicle, connect negative cable to negative post of the battery.
-
Using the DRB scan tool read and record active fault codes. Also read and record any stored fault codes..
-
Erase stored faults if there are no active fault codes. If problems remain, fault codes will not erase.
-
From the passenger side of the vehicle, turn ignition key to OFF and then ON observing instrument cluster air bag lamp. It should go on for six
to eight seconds, then go out. This will indicate that the air bag system is functioning normally.
9. If air bag warning lamp fails to light, blinks on and off or goes on and stays on, there is an air bag system malfunction.
10. Test the operation of the horn, lights and any other functions that are steering column operated. If applicable reset the radio and the clock.
11. Road test vehicle to ensure proper operation of the steering system and the speed control system.
