Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


Prowler V6-3.5L VIN G (1999)

Transmission and Drivetrain > Automatic Transmission/Transaxle > Bell Housing, A/T > Component Information > Service and Repair > Engine Bell Housing > Page 3143

Page 5
background image

Fig. 11

8. Install Special Tool # C-293-1 base into shop press (Fig. 11).

Fig. 12

9. Position bell housing into shop press (Fig. 12).

10. While holding onto bottom of shaft, press out shaft from bell housing.
11. Remove outer bearing from housing.

NOTE:  Replace crush sleeve whenever disassembling bell housing.

12. Remove crush sleeve from shaft.
13. Install Special Tool # P-334 splitter onto shaft. 

Transmission and Drivetrain > Automatic Transmission/Transaxle > Bell Housing, A/T > Component Information > Service and Repair > Engine Bell Housing > Page 3143

[PREV PAGE] [NEXT PAGE]