Aztek V6-3.4L VIN E (2001)
Inflatable Restraint Sensing and Diagnostic Module: Technical Service Bulletins
Air Bag - MIL ON, DTC B1001 Set After New SDM Install
File In Section: 09 - Restraints
Bulletin No.: 01-09-41-010
Date: November, 2001
TECHNICAL
Subject:
Air Bag Indicator Illuminated After Replacement of
Sensing and Diagnostic Module (SDM), DTC B1001
(Reprogram Body Control Module (BCM) to Accept New SDM)
Models:
2002 Buick Rendezvous
2001-02 Pontiac Aztek
Condition
Some technicians may encounter a condition where the Air Bag indicator is illuminated and a DTC B1001 is set after the replacement of the SDM.
Normal service diagnostics leads to replacing the SDM again.
Cause
The SDM part number stored within the BCM and the replacement SDM have different part numbers.
Correction
Verify the part number on the original SDM (if possible) and the new SDM (verify the part number on the shipping carton). If the part numbers are
different, the BCM will have to be reprogrammed using the Service Programming procedure.
Perform the following SPS reprogramming to allow the BCM to accept the new part number of the new SDM.
1.
Connect the Tech 2 to the vehicle DLC.
2.
Turn the key to the RUN position, engine off.
3.
Turn on the Tech 2.
4.
When the main screen is displayed on the Tech 2, verify that software version 21.007 or newer is loaded in the Tech 2.
5.
If the Tech 2 software is not 21.007 or newer, update the Tech 2. If the software is correct, continue by pressing Enter.
6.
Complete the normal Service Programming procedure using the Tech 2 and the Techline Terminal.
7.
After completing the Service Programming procedure, return to the main menu screen.
8.
From the main menu screen, Select F0, Diagnostics.
9.
Select the applicable model year.
10.
Select Truck.
11.
Press Enter.
12.
Select Body Style.
13.
Press Enter
14.
Select "A" (two wheel drive), or "B" (four wheel drive) as shown in the VIN.
15.
Press Enter.
