Firebird V8-305 5.0L (1982)
B.
The following individual part numbers can be used to service all transmissions which either were built with a forward sprag clutch after May
3, 1982, or have been converted with service package 8642947.
a.
8647083 - Snap Ring, Overrun Clutch Hub Retaining (#638)
b.
8647082 - Hub, Overrun Clutch (#639)
c.
8647081 - Wear Plate, Sprag Assembly (#640)
d.
8647085 - Retainer & Race Assembly (#641)
e.
8647084 - Forward Sprag Assembly (#642)
f.
8647090 - Race, Forward Clutch-Outer (#644)
g.
8647093 - Gear, Input Sun (#658)
h.
8647095 - Washer, Thrust (input Carrier To Race) (#660)
i.
8647050 - Carrier Assembly, Input-Complete (#662)
SERVICE INFORMATION
1.
Use the following procedure to assemble the forward sprag clutch.
a.
Place the forward clutch outer race (#644) on table with the recessed face down.
Figure 2
b.
Hold the forward sprag assembly (#642) (without brass retainer rings, #643) in your right hand. The crossbar notches in the sprag cage
must point to the left as viewed in Figure 2 (below).
c.
Install the sprag into the forward clutch outer race. Now, install a brass retainer ring (#643) on the sprag case. When properly installed,
the flanges of the retainer ring (#643) will face the sprag cage (refer to Figure 2).
Figure 3
d.
Install the retainer and race assembly (#641) into the sprag by pushing downward and rotating counterclockwise (see Figure 3 below).
e.
Turn the assembly over and install the remaining brass retainer ring (#643) on the sprag cage.