Firebird V8-305 5.0L (1982)
Motor Operates At One Speed In Both High & Low Switch Positions
1.
Disconnect electrical connector to wiper motor and alternately connect battery voltage to motor low and high speed terminals, Fig. 10.
2.
If motor runs at both low and high speeds, check continuity of wiring between motor and wiper switch. If wiring is satisfactory, wiper switch is
defective.
3.
If motor operates at one speed in both test positions, check for short between high and low speed motor brushes and repair as needed.
Motor Inoperative In Delay Mode
1.
Disconnect wiper switch electrical connector at pulse control module and connect ohmmeter between brown and dark green wire terminals in
connector.
2.
Meter readings should be approximately 50 ohms with switch in minimum delay position to 500,000 ohms with switch in maximum delay position.
3.
If readings are as specified, pulse control module is defective. If readings are not as specified, wiper switch is defective.
Fig. 10 Permanent magnet non-depressed park type windshield wiper motor. Exc. Citation, Omega, Phoenix & 1982---85 Skylark (Note: The harness connector may be labeled D-C-B-A instead of 1-2-3-4)
Motor Will Not Shut Off
1.
Disconnect electrical connector to wiper motor.
