G6 V6-3.5L VIN 8 (2005)
Air Door Actuator / Motor: Technical Service Bulletins
A/C - Revised Mode/Air Temp. Actuator Service Procedures
Bulletin No.: 05-01-38-013
Date: August 11, 2005
SERVICE MANUAL UPDATE
Subject:
Revised Air Temperature Actuator Replacement and Mode Actuator Replacement Procedures
Models:
2005 Pontiac G6
This bulletin is being issued to revise the Air Temperature Actuator Replacement procedure and the Mode Actuator Replacement procedure in the
HVAC-Manual sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin
on the affected page.
Air Temperature Actuator Replacement
Removal Procedure
1.
Remove the fuse labeled HVAC CTRL (BATT).
2.
Completely open the instrument panel (I/P) compartment door by pressing both tabs that support the stop bumpers. Refer to Compartment
Replacement - Instrument Panel (I/P).
3.
Remove the air temperature actuator screws.
4.
Remove the air temperature actuator.
5.
Disconnect the air temperature actuator electrical connector.
Installation Procedure
1.
Connect the air temperature actuator electrical connector.