G6 V6-3.6L (2007)
Important: To identify a camshaft drive design, refer to Camshaft Timing Drive Design Identification. See: Timing Components/Timing Component
Alignment Marks/Locations
Removal Procedure
1. Remove the lower intake manifold with the upper manifold. See: Intake Manifold/Service and Repair
2. Remove the right camshaft cover. See: Cylinder Head Assembly/Valve Cover/Service and Repair
3. Remove the right intake and exhaust camshaft position sensors. See: Powertrain Management/Computers and Control Systems/Camshaft Position
Sensor/Service and Repair
4. Remove the right intake and exhaust camshaft position actuator solenoids. See: Actuators and Solenoids - Engine/Variable Valve Timing
Solenoid/Service and Repair
Important: Rotate the crankshaft balancer bolt in a clockwise direction ONLY.
5. Rotate the crankshaft balancer using the balancer bolt until the camshafts are in a neutral (low tension) position. The camshafts will be parallel
with the camshaft cover rail (1).