G6 V6-3.6L (2007)
Pilot Bearing: Service and Repair
Clutch Pilot Bearing Replacement
Tools Required
^
J 38836 Bushing Installer and Clutch Arbor
^
J 43276 Clutch Pilot Bearing Remover
Removal Procedure
1. Remove the clutch. Refer to Clutch Drive Plate and Clutch Driven Plate.
Important: When using the J 43276, always secure the J 43276-1 tool body using a wrench. Do not allow the J 43276-1 tool to rotate.
Failing to do so causes damage to the J 43276-1 tool body.
2. Remove the clutch bearing using the J 43276.
1. Install the J 43276-1 into the clutch pilot bearing.
2. Using a wrench, secure the J 43276-1.
3. Insert the J 43276-2 into the J 43276-1.
4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
6. Remove the J 43276-1 from the tool body.
Installation Procedure
1. Install a 5/8 inch washer (1) onto the J 38836 or equivalent. The washer serves as a stop against the crankshaft face and will assist in installing the
bearing to the proper depth.
2. Install the new pilot bearing (2) onto the tool.
