G6 V6-3.9L (2009)
Assembly/Service and Repair).
4. Install the left lower ball joint to the left steering knuckle. Refer to Lower Control Arm Replacement (See: Steering and
Suspension/Suspension/Control Arm/Service and Repair/Front Suspension).
5. Install the left tie rod end to the left steering knuckle. Refer to Steering Linkage Outer Tie Rod Replacement (See: Steering and
Suspension/Steering/Tie Rod/Service and Repair/Steering Linkage Outer Tie Rod Replacement).
6. Install the left stabilizer shaft link to the left lower control arm. Refer to Stabilizer Shaft Link Replacement (See: Steering and
Suspension/Suspension/Stabilizer Bar/Stabilizer Link/Service and Repair).
7. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
8. Lower the vehicle.
9. Fill the transaxle to the proper level. Refer to Fluid Capacity Specifications (See: Specifications/Capacity Specifications).
10. Inspect the transaxle fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Symptom Related Diagnostic
Procedures/4T65-E - Automatic Transmission/Transmission Fluid Check).
11. Inspect for fluid leaks.
Front Wheel Drive Shaft Seal Replacement - Right
Front Wheel Drive Shaft Seal Replacement - Right Side
Special Tools
*
J 6125-B Slide Hammer
*
J 23129 Universal Seal Remover
*
J 29130 Axle Shaft Seal Installer
*
J 37292-B Axle Seal Protector
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the right front tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and
Repair).
3. Remove the right stabilizer shaft link from the right lower control arm. Refer to Stabilizer Shaft Link Replacement (See: Steering and
Suspension/Suspension/Stabilizer Bar/Stabilizer Link/Service and Repair).
4. Remove the right tie rod end from the right steering knuckle. Refer to Steering Knuckle Replacement (See: Steering and
Suspension/Steering/Front Steering Knuckle/Service and Repair/Front Suspension).
5. Remove the right lower ball joint from the right steering knuckle. Refer to Steering Knuckle Replacement (See: Steering and
Suspension/Steering/Front Steering Knuckle/Service and Repair/Front Suspension).
6. Remove the right drive axle from the transaxle. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair).
7. Secure the right drive axle to the right steering knuckle and the strut.
8. Use the J 6125-B (3) and the J 23129 (4) to remove the oil seal (1) from the extension housing (2).
Installation Procedure
1. Lubricate the seal lip with transaxle fluid.