G6 V6-3.9L (2009)
2. Install J 37292-B in the seal (4).
3. Use J 29130 to install the new seal (4).
4. Remove the J 37292-B .
Note: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
5. Install the drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair).
6. Install the right lower ball joint to the right steering knuckle. Refer to Steering Knuckle Replacement (See: Steering and
Suspension/Steering/Front Steering Knuckle/Service and Repair/Front Suspension).
7. Install the right tie rod end to the right steering knuckle. Refer to Steering Knuckle Replacement (See: Steering and Suspension/Steering/Front
Steering Knuckle/Service and Repair/Front Suspension).
8. Install the right stabilizer shaft link to the right steering knuckle. Refer to Stabilizer Shaft Link Replacement (See: Steering and
Suspension/Suspension/Stabilizer Bar/Stabilizer Link/Service and Repair).
9. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
10. Lower the vehicle.
Caution: Refer to Transmission Overfill Caution (See: Service Precautions/Transmission Overfill Caution).
11. Check and fill the transaxle fluid as necessary.
12. Inspect for fluid leaks.