G6 V6-3.9L (2009)
8. Install the wire harness retainer (2) to the control valve body cover stud and tighten the nut to 12 Nm (106 lb in).
9. Install the lower nuts to the left transmission mount. Refer to Transmission Mount Replacement - Left Side (See: Transmission Mount/Service
and Repair/6T70/6T75 - Automatic Transmission/Transmission Mount Replacement - Left Side).
10. Install the front transmission mount. Refer to Transmission Front Mount Replacement (See: Transmission Mount/Service and Repair/6T70/6T75
- Automatic Transmission/Transmission Front Mount Replacement).
11. Install the engine frame. Refer to Frame Replacement (Convertible) (See: Body and Frame/Frame/Subframe/Front Subframe/Service and
Repair/Frame Replacement (Convertible))Frame Replacement (Coupe 2.4L) (See: Body and Frame/Frame/Subframe/Front Subframe/Service and
Repair/Frame Replacement)Frame Replacement (3.6L) (See: Body and Frame/Frame/Subframe/Front Subframe/Service and Repair/Frame
Replacement)Frame Replacement (Coupe 3.5L, 3.9L) (See: Body and Frame/Frame/Subframe/Front Subframe/Service and Repair/Frame
Replacement).
12. Install the oil cooler inlet and outlet hoses to the retainer on the control valve body cover.
13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).
14. Fill the transmission. Refer to Transmission Fluid Replacement (See: Service and Repair/Removal and Replacement).
15. Check for leaks.
Control Valve Lower Body and Upper Body Replacement
Control Valve Lower Body and Upper Body Replacement
Removal Procedure
1. Remove the control valve body cover. Refer to Control Valve Body Cover Replacement (See: Control Valve Body Cover Replacement).
