Grand AM V6-3.4L VIN E (2001)
7. Install a NEW O-ring seal on condenser end of the evaporator hose assembly.
8. Install the evaporator hose assembly to the condenser.
Tighten
Tighten the fitting bolt to 24 N.m (18 lb ft).
9. Coat the O-ring seal with mineral base 525 viscosity refrigerant oil.
10. Install a NEW O-ring seal on the accumulator end of the evaporator hose assembly.
11. Install the evaporator hose assembly to the accumulator.
Tighten
Tighten the fitting nut to 25 N.m (18 lb ft).
12. Install the right front fender liner. Refer to Front Fender Liner Replacement.
13. Lower the vehicle.
14. Recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging.
15. Leak test the fittings of the repaired or reinstalled component using the J 39400-A.