Grand AM V6-3.4L VIN E (2001)
1. Install the SDM (5) to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the SDM mounting fasteners (1).
Tighten
Tighten fasteners to 10 N.m (89 lb in).
3. Install the SDM harness connector (3) to the SDM (5).
4. Install the Connector Position Assurance (CPA) (2) to the SDM harness connector.
5. Position the carpet to cover the Inflatable Restraint Sensing And Diagnostic Module (SDM).
6. Install the RF seat belt anchor bolt.
7. Install the passenger front carpet retainer.
8. Install the front passenger seat.
9. Enable the SIR system.
10. If the part number for the SDM has changed, it will be necessary to flash the BCM with the new part number. Refer to BCM Programming/RPO
Configuration in Body Control Module. See: Relays and Modules - Powertrain Management/Relays and Modules - Computers and Control
Systems/Body Control Module/Service and Repair