Grand Prix V6-191 3.1L VIN M SFI (1998)
10. Both rear frame bolts.
11. Power steering lines clamp from steering gear.
12. Line from steering gear.
INSTALL OR CONNECT
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require
thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors)
on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may
damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you
avoid damage to parts and systems.
1. Line to steering gear.
2. Line clamp and lines to steering gear.
3. Raise frame and align steering gear stub shaft to intermediate steering shaft.
4. New rear frame bolts.
5. Remove jack stands from frame.
6. Both tie rod ends and nuts to steering knuckles. Refer to POWER STEERING GEAR UNIT REPAIR.
7. Tighten right side engine splash shield.
CAUTION: When installing the intermediate shaft make sure the shaft is seated prior to pinch bolt Installation. If the pinch bolt is Inserted into
the coupling before shaft Installation, the two mating shafts may disengage.
NOTICE: Set steering shaft so block tooth on upper steering shaft is at the 12 o'clock position, wheels on vehicle are straight ahead and set
ignition switch to LOCK position. Failure to follow these procedures could result in damage to the SIR coil.
8. Intermediate shaft lower bolt.
-
Tighten bolt to 47 Nm (35 ft. lbs.).
9. Electrical connection to steering gear pressure switch.
10. Both front wheel and tire.
11. Lower vehicle.
12. Remove J 28467-A, J 28467-90 and J 36462.
13. Air cleaner and duct.
14. Fill system. Refer to CHECKING AND ADDING FLUID. See: Steering and Suspension/Steering/Service and Repair
Adjust
-
Bleed power steering system. Refer to BLEEDING POWER STEERING SYSTEM. See: Steering and Suspension/Steering/Service and Repair
Inspect
-
For leaks. Refer to STEERING TESTING AND INSPECTION PROCEDURES.