Montana V6-3.4L VIN E (2002)
Condition 3
Some customers may comment on a mildew odor or that the front floor is wet.
Cause
The wire harness, cables or the HVAC drain that passes through the front of dash may not be sealed properly. Refer to the arrows in the above
illustration.
Correction
Locate the leak by running water down the front of the dash under the hood. Clean the area with one of the cleaners listed below. Seal the area with a
seam sealer listed below.
Condition 4
Some customers may comment on water dripping from the top of the windshield.
Cause
Important:
A large amount water may be able to enter the vehicle through small holes in the body seam sealer.
^
To check for a void in the windshield urethane, run LOW pressure water under the windshield surround molding.