Vibe L4-1.8L VIN L (2003)
1. Install the foot rest (5) to the floor panel studs. Secure the foot rest, by fastening the 2 plastic retainers (4).
Garnish Molding Replacement - Body Side Lower Rear
GARNISH MOLDING REPLACEMENT - BODY SIDE LOWER REAR
REMOVAL PROCEDURE
1. Remove the rear seat assembly.
2. Remove the bolt (2).
3. Remove the rear seat hinge (3).
4. Gently pry the rear body side lower garnish molding plastic retainers and remove the molding (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the rear body side lower garnish molding (1) to the vehicle. Ensure that the plastic retainers are fully seated.
2. Install the rear seat hinge (3) to the rear body side lower garnish molding (1).
3. Install the bolt (2) to the rear seat hinge (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the rear seat hinge bolt to 18 N.m (13 lb ft).