Vibe FWD L4-1.8L VIN 8 (2004)
Rear Bumper Reinforcement: Service and Repair
Impact Bar Replacement - Rear Bumper
Removal Procedure
1. Remove the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper (See: Rear Bumper Cover / Fascia/Service and Repair) .
2. Remove the rear bumper fascia energy absorber. Refer to Energy Absorber Replacement - Rear (See: Rear Bumper Shock Absorber/Service and
Repair) .
3. Remove the following components from the vehicle:
*
The 4 nuts (2)
*
The rear bumper impact bar (1)
*
The 4 push-in retainers (3) and the 2 rear bumper stays (4) from the impact bar (1), if necessary
Installation Procedure
Notice: Refer to Fastener Notice in Cautions and Notices.
1. Install the 2 rear bumper stays (4) and the push-in retainers (3) to the impact bar (1), if removed.
Install the rear bumper impact bar (1) to the vehicle. Secure the impact bar with 4 nuts (2).
Tighten the rear bumper impact bar nuts to 36 N.m (26 lb ft).
2. Install the rear bumper fascia energy absorber. Refer to Energy Absorber Replacement - Rear (See: Rear Bumper Shock Absorber/Service and
Repair) .
3. Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper (See: Rear Bumper Cover / Fascia/Service and Repair) .