911 Carrera (997) F6-3.6L (2006)
7. Position clamping tool universal piston ring restraining strap, 75 - 125 mm NR.55 on the piston; when doing so, ensure that the piston rings are
positioned correctly. Adjust restraining strap to piston diameter, use tensioning lever -1 - and tensioning screw -2- to fine-tune the adjustments.
8. Coat cylinder bores 1-3 with plenty of new engine oil.
9. Insert piston, together with connecting rod, into cylinder bore 1 , universal piston ring restraining strap, 75-125 mm NR.55 must lie evenly on
cylinder surface.
10. Pay attention to direction of assembly: arrow on piston crown always points to flywheel side
ATTENTION: Incorrect and careless assembly of pistons.
^
Component damage (pistons, piston rings, cylinder line)
^
Assemble pistons carefully and gently.
^
Stop process immediately if there is increased resistance during assembly; eliminate the cause of the problem.
11. Hold the piston ring restraining strap firmly and press piston in a cable into the cylinder bore using a plastic mandrel.
12. Check installation position of connecting rod: In the installation position, the recesses of the twist lock in the connecting rod bearing point towards