911 Carrera 2 Targa F6-3600cc 3.6L SOHC (1992)
Disassembly
NOTE:
-
Items 1 through 20 are removed without removing the drive pinion.
-
To facilitate reassembly, the drive pinion remains installed for part of the dismantling steps.See: Service and Repair/G50
Disassembly/Assembly/Disassembly/Assembly of Transmission
Assembly
-
Mount tensioning plate with input shaft in vice (fit protective jaws) and reassemble drive pinion.
A = Large inner race (Outside diameter 56 mm), pointing towards pinion head when installed
B = Small inner race (outside diameter 53.5 mm), pointing towards 4th gear fixed gear.
-
Heat bearing inner race of four-point bearing to approx. 120°C and press into correct position.
-
When installing the synchronizer driver dogs, the guide nose must face the selector sleeve. The nose may point either to the left or the right.
Assembly dimension (new) = 1.1 mm min.
Wear limit = 0.6 to 0.7 mm
-
To check the synchronizer rings, press rings onto the gear cones and use a feeler gauge to measure gap "A".