911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
/f6-3.4l/Page-1061002.png)
NOTE: The brake pad quality on the front and rear axles is identical. The pad backing plates (rear side of the brake pads) must not be greased.
-
Fit new expanding spring, new retaining pin and new retainer (safety bracket) (arrow). These parts are available as a repair set and must be
"renewed" each time the pads are changed.
-
Insert the warning contact wire and warning contacts.
-
Firmly press the brake pedal several times with the vehicle stationary so that the brake pads assume their fit in accordance with the operating state.
Next, check and, if necessary, correct the brake fluid level.
Bedding in the brake pads
New brake pads require a bedding-in period of approx. 200 km. Not until then do they achieve their best friction and wear coefficient. During this
period, the brakes should be subjected to full stress when travelling at high speed only in emergencies.
