911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
7. Place oil extraction pump in the cylinder head.
Note: For reasons of space, the oil extraction pump must be fitted before the cylinder head cover is installed.
8. Lightly grease the new sealing ring and lay it in the oil extraction pump. Align oil extraction pump driver and fit oil extraction pump in the correct
position. The arrow for the direction of rotation or the marking 1 - 3" must face the crankcase. Insert new micro-encapsulated hexagon--head bolts
loosely in the oil extraction pump. Rear axle cross member removed for clearer illustration
9. Prepare cylinder head cover for installation: Clean sealing surface of the cylinder head and cylinder head cover very carefully. Apply a silicone
bead to the cylinder head cover. Refer to: Sealing cover for camshaft housing (cylinder head cover).
10. Carefully place the cylinder head cover in the correct position so that the sealing bead is not damaged. Screw two studs or centering pins into the
corners of the cylinder head as centering aids. Tightening torque 13 Nm (10.0 ft. lbs.). Observe tightening sequence.
11. Remove holding-down device 9634.
12. Immediately remove silicone material emerging in the area of the camshaft closure cap.