911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
/f6-3.4l/Page-460004.png)
4. Fit insertion tool No. 9699 between the two internal M8 pan-head screws, (hexagon socket a/f 8) -with hexagon socket wrench insert- on the
crankshaft flange and fasten it. The crankshaft flange's dowel pin must sit in the bore of the device.
5. To position the crankshaft sealing ring correctly on the crankshaft flange, turn an open-end/ring wrench in a clockwise direction as far as it will go
on the hexagon (a/f 19) of the device -Figure-. Then, remove the tool.
6. Install the DMF or drive plate. Make sure that the crankshaft flange is not damaged.
7. Install the clutch pressure plate and drive plate.
8. Refit or install the transmission.
9. Install the engine/transmission unit if necessary.
