911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
/f6-3.4l/Page-1146002.png)
1. The angled cable lug of terminal 50 (M6) faces in driving direction (transmission) after assembly.
Arrow shows marking (line) on the intake distributor
2. Carefully centre the intake distributor. Push both rubber sleeves onto the intake distributor up to the marking (line) and secure (2 hose clamps).
3. Check bore in the rubber sleeves for check valve and vacuum to the fuel pressure regulator for clear passage.
4. Engage accelerator cable and install throttle body. Fit fastening screw M6 x 20 at the bottom right.
5. Tighten the outer hose clamps of the rubber sleeve after securing the throttle body on the hydraulic pump housing. The throttle body must not
contact the hydraulic pump housing.
6. The intake system must be checked for leaks after assembly (visual inspection).
