911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
/f6-3.4l/Page-921005.png)
9. Remove retainer (1) on the pedal bearing axle.
10. Undo fastening nuts from boost spring bracket (arrows). Requirement: Boost spring secured with a cotter pin. Remove clutch pedal lever together
with boost spring and bracket.
Installation
1. Inspect all bearing bushings X for clutch pedal lever and replace them if necessary. Lubricate sliding surfaces of the bearing bushings X (see
Figure) and the pedal bearing axle with Optimal, Optitemp LG 2, Part No. 000.043.203.37.
2. Assemble boost spring, bracket and clutch pedal lever.
Note: In the 911 Carrera (996), different boost springs may be fitted. Observe proper allocation when replacing the boost spring and/or the
bracket.
A modified (optimized) clutch pedal must also be sometimes be using when replacing the boost spring.
Greasing of the boost spring bearing points is partly necessary and partly not permitted (depending upon the type of boost spring used).
2.1 Carrera (996) Mod. '98 / some Mod. '99
Identification/differentiation: Push rod of boost spring open on one side, boost spring parts not coated.
