911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
4. Fit new retainer on the pedal bearing axle and subsequently secure the retainer by wedging it with a mandrel.
5. Install clutch pedal switch. First pull operating plunger out of the switch as far as it will go. By means of its self-adjustment function, the switch
then compensates for tolerances in the pedals.
6. Check the interlock switch adjustment on vehicles with interlock.
Adjustment specification for interlock switch:
The switch must be aligned so that, with the clutch pedal depressed, it is operated approximately 1 to max. 2 mm before the limit stop of the clutch
slave cylinder is reached.
7. Install relay carrier, diagnostic socket and air duct.
8. Perform a function test on clutch and brake operation.