911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
7. Connect vacuum hoses and cable plugs on the switch-over valve -6-.
8. Fasten hose holder (Tiptronic only) on the left intake distributor. To do this, tighten the M6 hexagon-head screw and push on the pipe connector of
the vacuum line to the brake booster -3-. Then press the plastic clip in and secure the line.
Tightening torque for the M6 hexagon-head bolt 10 Nm (7.5 ftlb.)
9. Push top coolant hose -1- onto the filler neck of the coolant expansion tank, then fasten the spring-band clamp.
10. Then push on hose of the secondary-air pump -4- again.
11. Fit coolant hose -arrow-. To do this push on the coolant hose and fasten the spring-band clamp with a set of spring-band clamp pliers.
12. Raise the engine with the jack and then tighten the two M12 collar nuts (a/f 18) on the rear engine mounts.
Tightening torque 85 Nm (63 ftlb.)
13. Connect plug connection of the fuel line -1-. Fit fuel line and plastic holder on the coolant expansion tank.
14. Push on cable plug of the coolant level sensor -5-.
15. Install the air-conditioning compressor. To do this, fit the aluminium spacer sleeve and tighten three M8 hexagon-head bolts. Connect the ground
cable at the plug connection.
16. Install air cleaner housing.
17. Check the coolant level.
18. Connect the battery.
Tightening torques