911 Carrera Cabriolet (996) F6-3.4L (1999)
11
-
Removing convertible-top covering at the corner bow
1. Undo the bond of the inner cloth covering -inset A- around the corner bow.
2. Fold the convertible-top covering forwards to the roof frame.
3. Pull seal -arrow B- out of the groove of the corner bow and disengage the covering strip of the convertible-top covering in downward
direction.
12
-
Removing convertible-top covering at the main bow
1. Pull the tightening strip of the convertible-top covering -16- from the groove of the main bow -17-. Remove convertible-top covering from
the vehicle.
Installing the convertible-top covering
All pins and screw joints must be checked for tightness before the convertible-top covering is installed. Refer to "Assembling convertible-top
frame".
The tension strap and the bracing strap must be replaced before fitting the convertible-top covering. Refer to "Installing tension strap".
The rear glass window must be installed before fitting the convertible-top covering. Refer to "Removing and installing rear glass window of
Cabriolet".
1
-
Fastening convertible-top covering at the main bow
-
Lay the convertible-top covering on the convertible-top frame, fit the front tightening strip -16- of the convertible- top covering in the
groove of the main bow -17- and centre.
2
-
Fitting convertible-top covering at the corner bow
1. Press tightening strip centre (notch marking) into groove of the corner bow (centre of the corner bow is identified by a hole).
The tightening strip is secured by tapping in the seal -arrow B-.