911 Carrera Cabriolet (996) F6-3.4L (1999)
6
-
Fastening convertible-top covering at front
A cardboard strip and a self-adhesive strip are affixed at the front of the convertible-top covering.
1. Pull the protective film off the Teflon adhesive tape.
2. Fold the convertible-top material around the roof frame edge without wrinkles. The convertible-top covering is initially held with fixing
clips.
7
-
Fastening the retaining rail and convertible-top seal on the roof frame 1
1. Remove the fixing clips.
2. Insert convertible-top seal -12- at the front corners into roof frame 1 in -direction of arrow- and tighten with torx screws T25 -11-.
Tightening torque: 1.7 Nm (1 ftlb.)
1. Position the retaining rail -10- on roof frame 1 and tighten using T25 Torx screws -9-.
Tightening torque: 3.5 Nm (2.5 ftlb.)
8
-
Fastening seals and retaining strip at the sides of the roof frame
The seal on the roof frame at the sides consists of two parts.
1. Position the upper seal -6- onto the retaining strip -7- in -direction of arrow A- and screw on to roof frame with the Torx screws T15 -8-.
Tightening torque: 2.8 Nm (2 ftlb.)
1. Press the lower seal -5- into the profile of the retaining strip -7-.