911 Carrera Cabriolet (997) F6-3.6L (2007)
4. Pull the line and the rubber sleeve out of the passage to the plenum panel over the wheel housing.
Installing the condenser-fluid tank line
1. Push line into the plenum panel via the wheel housing and press rubber sleeve into place. Ensure that rubber sleeve is fitted correctly.
INFORMATION: When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
2. Clip line into the line holder at the top, insert line into the condenser and screw down with -2- fastening screw. Tightening torque: 14 Nm (10.5
ftlb.)
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.