911 Carrera Cabriolet (997) F6-3.6L (2007)
2. Remove control module, disengage the connector housing -arrow A- to the right, and pull it down and off. Press plug connection -arrow B-
together and pull it down and off. Disengage plug connection -arrow C- upward and to the right, and pull it down and off.
Installing control unit for convertible top
Installing control unit for hood
NOTE: If the control unit for the convertible top must be replaced, first the values must be read from the control unit using the PIWIS tester 9718.
Refer to Removing and installing convertible top control unit
1. Join electric plug connections -arrow C- and engage the locking lever downward. Connect the plug connection -arrow B-. Join plug connection
-arrow A- and press the plug housing to the left until it engages. Lay lines carefully (do not trap).
2. Position the control unit and secure with both fastening screws -1-. -] Tightening torque: 4.8 Nm (3.5 ftlb.)