911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-35002.png)
--> During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery charger with a
current rating of at least 40 A to the vehicle battery.
--> Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
Note
^
The control unit is located in the passenger compartment on the right at the B-pillar in front of the rear seat well.
^
The ignition key must be removed before starting the assembly work.
^
If the Tiptronic control module is replaced, observe the points under programming/coding the control unit.
1. Unscrew lower fastening screw for the seat belt.
2. Disengage floor covering at the support and lay it in the vehicle interior.
3. Unlock locating peg -1- of the support using the commercially available removal tool Disassembly tool, universal NR.21.
4. Unscrew fastening screws -2- and nuts -3- and carefully pull the support up and out of the retaining points.
5. Unlock and disconnect the electrical plug connection.
