911 Carrera Cabriolet (997) F6-3.6L (2007)
2. Loosen and unscrew fastening screws on flywheel. Carefully take off flywheel (watch the thread!). Undo fastening screw for toothed segment.
Note: Check the friction surface of the flywheel. The flywheel must be replaced if it is damaged or discolored.
3. Inspect the friction surface of the flywheel visually.
Installing double-mass flywheel
Installing double-mass flywheel
Note: Before re-installation, clean the friction surface of the flywheel with a clean lint-free cloth that has been soaked in solvent naphtha or acetone.
1. Position double-mass flywheel on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all fastening screws (8).
2. Align toothed segment 9538/1 and tighten fastening screw again.
3. Screw in and tighten fastening screws in diagonally opposite sequence. -> Initial tightening: 19 ftlb.; -> Final tightening - torque angle: 120°
4. Remove toothed segment.
Subsequent work
Subsequent work for double-mass flywheel
1. Install clutch.
2. Install manual transmission.