911 Carrera Coupe F6-3164cc 3.2L (1984)
Case: Service and Repair
Front Cover
Disassembly/Assembly No Oil Pump
-
Drive in seal for selector rod to correct position with Special Tool P 369.
Disassembly/Assembly Oil Pump Equipped
NOTE: Because of the ability to interchange Porsche transmissions, it is possible to find an oil pump equipped transmission in a later model.
Disassembly
-
Heat transmission cover to approximately 120°C (250 °F) and pull speedometer gear shaft bushing out; drill out, if necessary.
Assembly
-
Heat transmission cover to approximately 120°C (250 °F) and drive gear shaft bushing in with a suitable mandrel.
-
Drive on seal for shift rod with special tool P 369.