911 Carrera Coupe F6-3164cc 3.2L (1984)
Case: Service and Repair
Transmission Housing
Disassembling
-
Drive shift detent securing roll pins out.
-
Drive half-round dowel pin out.
NOTE: Detent components are under spring tension. Therefore, always remove the roll pin first, then the half-round dowel pin.
-
Heat gear housing to approximately 120°C (250 0F) and drive bearing outer races out using special tool US 8050.
Assembling
-
Heat housing to approximately 120°C (250°F) and drive bearing outer races in with special tool US 8050.
CAUTION: The bearing outer races differ in inside diameter. The race with the larger inside diameter belongs to the pinion shaft (lower shaft).
-
Install 5th and reverse speed shift rod.
-
Insert long detent and drive roll pin in.
-
Install spring and sleeve, tension both with special tool P 366, and drive roll pin in.
-
Insert pin and detent (short), then drive the plug in. Reference next image for locations.