911 Carrera Coupe F6-3164cc 3.2L (1984)
Differential Carrier Assembly: Service and Repair
Late Production
Disassembly
-
Pull off taper roller bearing inner races with a puller (e. g. US 1078) and Special Tool P 263.
NOTE: Claws of both arms must be machined, if necessary.
-
Unlock and remove ring gear bolts.
-
Knock ring gear off of case with a suitable mandrel.
Assembly
-
Heat ring gear to about 120°C (248°F) and install. Use locally made centering pins as guides.
-
Install ring gear retaining bolts.
^
Torque to:: material 11.9 - 115-120 Nm (84-88 ft lb)
material 12.9 - 150-160 Nm (110-118 ft lb)
-
Push lockplate in groove of bolts, squeeze front with pliers (so that lockplate is connected tightly on bolts) and bend down over a hexagon surface
to lock.