911 Carrera Coupe F6-3164cc 3.2L (1984)
Seals and Gaskets: Service and Repair
Differential Side Seal, Manual Transaxle
Removal
-
Unscrew joint flange mounting bolt and remove joint flange.
-
Drive seals and bearing outer races out of final drive housing and side cover with an appropriate drift.
Installation
-
Install seal in final drive housing with special tool P 256c.
-
Install seal in side cover with special tool P 265c.
NOTE: The joint flanges and mounting bolts were also changed with introduction on the new differential (similar to 928). A M10 x 80 hexagon
head bolt without washer is used on these transmissions to mount the joint flanges instead of the expansion bolt with washer.
