porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Removing and Installing Roll-Over Bar - GT3|Page 6218 > < Removing and Installing Roll-Over Bar - GT3|Page 6216
Page 2
background image

The screwed roll cage is not fully fitted on vehicle delivery if the vehicle is supplied with Club Sport equipment. The front sections (A-pillar support) of
the roll cage which are delivered separately from the vehicle must be fitted on to the base cage.

NOTE:  The legally permissible treatment must be obtained from the relevant national importer.

CAUTION:

1. Danger of head injuries in the event of an impact with the roll cage.
2. When driving with the standard three-point belt, there is a possibility that, in the event of an accident, an occupant's head may come into contact

with the roll cage.
-

The A-pillar struts should only be installed if the vehicle is to be used immediately on closed circuits.

-

If the car is to be used on the road again (after being used for racing purposes), it is advisable to remove the A-pillar struts again, depending on
the size of the occupants. The rear section of the cage can remain installed permanently.

-

The three-point belts must be fastened when driving on public roads.

Adjusting The Roll-Over Bar

Removing and Installing Roll-Over Bar - GT3|Page 6218 > < Removing and Installing Roll-Over Bar - GT3|Page 6216