911 Carrera Coupe (996) F6-3.6L (2002)
4. Pull out sealing ring by screwing in the hexagon-head bolt.
Installing sealing ring for drive shaft
1. Push assembly sleeve No. 9255 onto the toothing of the input shaft.
2. Fill the space between the dust and sealing lips on the sealing ring with grease (e.g. Liqui-Moly).
3. Drive in sealing ring with pressure piece No. 9256 as far as the mounting face.
Note! The guide tube fastening screws are micro-encapsulated, therefore replace screws entirely.
4. Install guide tube and tighten the fastening screws.