911 Carrera S Cabriolet (997) F6-3.8L (2007)
Joint flange for oil regulating valve
2. Remove oil pressure pipe.
2.1.
Unscrew three outer Torx(R) screws (E10) M6 x 16.
2.2.
Pull out pressure pipe and replace O-ring on the pipe and on the oil pump.
Oil pressure pipe for oil pan
3. Remove air/oil separator.
3.1.
Unscrew five outer Torx(R) screws (E10) M6 x 20. Move the separator and line into vertical position at the belt side and then pull out the
connecting line at the oil pump.
3.2.
Replace O-ring on the line going to the oil pump.
Oil/air separator on oil pan
4. Remove suction tube and oil deflector (watertight sheetmetal panel).
4.1.
Unscrew one inner Torx(R) screw (T30) M6 x 25 and pull suction tube out of the oil pump. Replace O-ring.
4.2.
Unscrew one outer Torx(R) screw (E10) M6 x 20 and pull off the oil deflector. Replace two O-rings.