911 GT2 (996) F6-3.6L Turbo (2003)
7. Unlock plug of the rate-of-turn sensor with the ignition switched off -arrow on the plug- and pull it off. Undo fastening nuts -arrows- and
remove the rate-of-turn sensor with bow.
NOTE: Pull at the plug housing only. Never pull the electrical connections.
8. Remove the airbag control module. See Removing and Installing Triggering Unit for the Airbag.
NOTE: Socket wrench insert 9259 is required for removal and installation of the airbag triggering unit
9. Undo the fastening screws -arrows- on both sides and remove the holder -2-. To do this, guide the electrical wiring and, if necessary, the keylock
cable through the holder opening.