911 GT2 (996) F6-3.6L Turbo (2003)
-
Fit rate-of-turn sensor (new/current version) -3- part no. 999.606.145.00. First, feed (route) the adapter lead -X- under the rate-of-turn sensor
-3-. Then connect the plug -arrow- on the adapter lead -X- to the rate-of-turn sensor -3-.
NOTE: There is no bow over the new rate-of-turn sensor.
5. Prepare new/current support -B- (with dimension X = approx. 8 mm) for installation. Distinguishing characteristics: Dimension X and diameter of
the hole -arrows-. Dimension X of the holder for the first version -A- approx. 12 mm.
6. Install new/current support -B-.
7. Install centre console -C-. Then install centre console front part -B-.
8. Install side panel linings in front of the centre console.
9. Connect battery ground cable.