911 GT2 (996) F6-3.6L Turbo (2003)
43. Detach the oil supply lines from the bracket (left-hand side).
44. Remove auxiliary screw again.
45. Remove complete bracket. Simultaneously pull off coolant hoses.
46. Undo oil pump fastening screws and remove the cover.
47. Check oil pump cover and contact surface of the oil pump gears in the bracket for signs of seizing or excessive wear. The entire bracket must be
replaced if necessary. The bracket, oil pump gear and oil pump cover are matched.
Installation
Removing and Installing Oil Pump For Turbocharger
Installation
1. Grease oil pump gears and contact surfaces with Optipit assembly grease. Make sure that grease does not enter the receiving bores for the dowel
pins.