911 GT2 (996) F6-3.6L Turbo (2003)
2. Insert oil pump gears in the housing. The all-round groove of the outer oil pump gears must face the oil pump cover.
3. Fasten oil pump cover. When tightening, simultaneously check the operating smoothness of the oil pump. Tighten the screws crosswise.
Tightening torque 10 Nm (7.5 ftlb.).
4. Prepare bracket for installation. Unscrew plug (Torx T30).
5. Fit new O-ring on the oil pump cover and new O-rings on the lower coolant connection flanges. Apply a thin coat of Vaseline on the O-rings.
6. Position bracket on the crankcase and simultaneously use a screwdriver to connect the oil pump drive shaft and the intermediate shaft. Do not use
excessive force; gently press in place by hand.