911 SC Cabriolet F6-2994cc 3.0L SOHC (1983)
d
Press out outer race of the outer tapered roller bearing on shop press using special tools VW 407, VW 418, VW 447f, Spacer 1, and VW 401.
Installation
Note the following points during installation:
General: Tapered roller bearings of various brands (SKF. FAG and Tirnken), are installed during assembly at the plant. New bearing parts, such
as the outer race, inner race and roller are interchangeable within a given brand but care must be taken that the complete bearing consists of
one-brand parts.
1. Thoroughly clean both tapered roller bearings and check for wear or damage. replace if necessary.
2. Heat wheel hub to 120 - 150°C (250-300°F).
3. Press in the outer race of the inner roller bearing on shop press using special tools VW 407. VW 477i, Spacer 1, and VW 401.
4. Insert the inner race into the inner tapered roller bearing and press oil seal in with the help of special tools VW 410, VW 433. Spacer 1, and VW
401 until the oil seal is flushed with the wheel hub housing.
