911 Targa (996) F6-3.6L (2004)
Cross-Member: Service and Repair
New Front-Axle Cross Member - As of Model '02
New front-axle cross member - as of model '02
^
As of model '02, the front-axle cross member is attached to the body at the rear fastening with two screws -arrows-. Up to this (up to the end of
model '01), only one screw was used in the fastening.
^
The tightening torque has not been changed.
^
The previous front-axle cross member -F1-, with one fastening screw securing it to the body (per side) is still available as a spare part.
^
Only certain combinations of front-axle cross member attachment -F1 or F2- to the body is permitted!
F2 2 fastening points (as of model '02)
F1 1 fastening point