911 Targa (996) F6-3.6L (2004)
Cross-Member: Service and Repair
Allocating the Front-Axle Cross Member to the Body
Allocating the front-axle cross member to the body
Caution: Material damage will result in the area of the axle mount/axle fastening due to reduced strength, if correct allocation is not observed!
^
Only install permissible combinations of front-axle cross member to the body (standard construction)!
^
Do not install front-axle cross members with one fastening screw (F1) in vehicles with two body mounting points (K2)!
Impermissible combination
Front-axle cross member with one fastening bore -F1- and body with two fastening points -K2-.
^
Attention: Impermissible combination!
Permissible combinations
Front-axle cross member with one fastening bore -F1- and body with one fastening point -K1-.
^
Standard construction up to end model '01.
Front-axle cross member with two fastening bores -F2- and body with two fastening points -K2-.
^
Standard construction as of model '02.
Impermissible combination
The combination - front-axle cross member with two fastening bores and (F2) and body with one fastening point (K1) - is not possible!