911 Targa (996) F6-3.6L (2004)
The rear glass window must be installed before fitting the convertible-top covering.
1. Fastening convertible-top covering at the main bow
Lay the convertible-top covering on the convertible-top frame, fit the front tightening strip -16- of the convertible-top covering in the groove of the
main bow -17- and centre.
2. Fitting convertible-top covering at the corner bow
a. Press tightening strip centre (notch marking) into groove of the corner bow (centre of the corner bow is identified by a hole).
The tightening strip is secured by tapping in the seal -arrow B-.
b. Coat the cloth covering with adhesive and stick it inside around the corner bow -inset A-.
3. Fastening holding strap of the convertible-top covering
a. Position holding strap at the right on convertible-top frame 3 on the inside and press in the clip.
On the left side, the holding strap is fastened with the fastening clip of the wiring harness.
4. Fastening the fastening strap at the main bow
a. Turn the vertical fastening strap of the convertible-top covering inward around the main bow, and place it on the shaped sheetmetal part. Screw
in with the oval-head screws -B- T15 M3.5.
Tightening torque 1.7 Nm (1 ftlb.)
b. Position wedge on the main bow and screw in place with the fastening screws T25 M5 -A
Tightening torque 2.8 Nm (2.0 ftlb.)